Makita 4101rh Instruction Manual page 7

Adjusting bevel angle
1
003515
Loosen the wing nut on the bevel scale plate on the front
of the base. Set for the desired angle (0° - 45°) by tilting
accordingly, then tighten the wing nut securely.
Loosen the wing bolt on the depth guide and move the
base so that the end of the blade case is above the red
line on the depth guide. Then tighten the wing bolt to
secure the base.
003516
NOTE:
If the end of the blade case is under the red line on
•
the depth guide, the outer flange may hit the
workpiece when you perform the bevel cut.
Sighting
2
003520
For straight cuts, align the "A" position on the front of the
base with your cutting line. For 45° bevel cuts, align the
"B" position with it.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
1. Wing nut
1. Wing bolt
1
2. End of blade
case
3. Red line
2
3
1
1. Base
2. Top guide
A
B
1
003523
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, push in the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing diamond wheel
1
003528
Hold the outer flange with the wrench and loosen the hex
socket head bolt clockwise with the hex wrench. Then remove
the hex socket head bolt, outer flange and diamond wheel.
Install the diamond wheel, outer flange and hex socket
head bolt onto the spindle. Hold the outer flange with the
wrench and tighten the hex socket head bolt
counterclockwise with the hex wrench. BE SURE TO
TIGHTEN THE HEX SOCKET HEAD BOLT SECURELY.
1
003529
CAUTION:
Use only the Makita wrench to install or remove the
•
wheel.
7
1. Switch trigger
2. Lock-off button
2
1. Wrench 22
2. Hex wrench
2
1. Inner flange
2 3 4
2. Diamond wheel
3. Outer flange
4. Hex socket head
bolt