The Router's Front Panel - NETGEAR Wireless ADSL Modem Router Setup Manual

Wireless ADSL Modem Router Setup Manual

The Router's Front Panel

The wireless ADSL modem router front panel shown below contains status LEDs.
1
2
Figure 1-1
You can use the LEDs to verify various conditions.
Table 1-1. LED Descriptions
Label Activity
On
1. Power
Off
On
2. Test
Off
Blink -- Amber
On -- Green
3. Internet
Blink -- Green
On
4. Wireless
Off
On (Green)
Blink (Green)
On (Amber)
5. LAN
Blink (Amber)
Off
1-2
3 4
5
Table 1-1
Description
Power is supplied to the router.
Power is not supplied to the router.
The system is initializing.
The system is ready and running.
Indicates ADSL training.
The Internet port has detected a link with an attached device.
Data is being transmitted or received by the Internet port.
Indicates that the Wireless port is initialized.
The Wireless Access Point is turned off.
The Local port has detected a link with a 100 Mbps device.
Data is being transmitted or received at 100 Mbps.
The Local port has detected a link with a 10 Mbps device.
Data is being transmitted or received at 10 Mbps.
No link is detected on this port.
v1.1, 2006-2
describes each LED.
Connecting the Router to the Internet