NETGEAR GA511 User Manual page 20

NETGEAR 10/100/1000 Mbps CardBus Adapter GA511 User Manual
Finally, Verify connectivity to your network.
a. Connect one end of a Cat 5 (or higher) Ethernet cable to the GA511 Gigabit CardBus
Adapter.
b. Connect the other end of the cable to an RJ-45 Ethernet network port.
c. Turn on power to the notebook computer and then to the connected device.
d. Verify that one of the LEDs is on, indicating that there is a good link to the card.
e. Click the GA511 system tray NETGEAR Smart Wizard utility icon
right side of the Windows task bar. Verify that the GA511 status information matches your
network.
If there is a problem with the installation of the driver, an exclamation point will appear
next to the NETGEAR GA511 Gigabit Adapter. Try rebooting your computer.
Note: If you are unable to connect, see troubleshooting tips in
2-6
NETGEAR GA511 Smart Wizard Utility
v2.0, March 2007
on the lower
"Troubleshooting" on page 3-3.