Basic Installation Instructions - NETGEAR GA511 User Manual

2. When the Windows system boots up after installing the GA511 Gigabit CardBus Adapter, the
system automatically detects the new hardware and prompts you to install the driver software
for the device. Follow the prompts of the Found New Hardware Wizard to automatically use
the driver installed in step 1.
If you are installing more than one GA511 Gigabit CardBus Adapter, you must perform these steps
for each card.

Basic Installation Instructions

Use the procedure below for installation on a Windows Vista, XP, 2000, 98SE 2nd edition, or Me
system.
F ,
IRST INSTALL THE
a. Power on your notebook, let the
operating system boot up completely,
and log in as needed.
b. Insert the NETGEAR Adapter Resource
CD into your CD-ROM drive. The
Adapter Resource CD main page will
load.
c. From the Windows Start menu, select
Run. The Run dialog box opens.
d. Enter the path to the GA511 setup.exe
file on the CD. For example, if your CD-
ROM is drive D, enter
D:\GA511\setup
Then, click OK.
e. Follow the InstallShield Wizard steps,
click Finish when done, and if prompted,
restart your computer.
Now, the GA511 driver and utility software
are installed.
NETGEAR 10/100/1000 Mbps CardBus Adapter GA511 User Manual
GA511 .
SOFTWARE
as the path.
v2.0, March 2007
Adapters Resource CD
Windows Start > Run
2-3