Connecting To Pbx - NEC MATWORX NWA-008862-001 Installation Manual

CHAPTER 3 Office Data Converter

4. Connecting to PBX

4. Connecting to PBX
1. Set the office data as shown below from CAT and
set the data transmission speed to 9600 bps of the
serial port of the former system that reads out the
office data.
CM40 YY=08
First data
Second data: 4 (9600 bps)
2. Connect the former system (RS connector of the
MP card) and the PC that will execute the Office
Data Converter using a MAT cable.
NOTE:
Page 58
: 0/1 (port 0/port 1)
Be sure to connect directly between the
former system and the PC using a MAT
cable.
(Do not make a remote (modem) connection
or a LAN connection.)
NWA-008862-001 Rev.2.1
ajch3001.fm