Lan Connection - NEC MATWORX NWA-008862-001 Installation Manual

LAN Connection

You can connect your PC to the PBX via the Ethernet
LAN.
PBX
MP
ETHER
NOTE:
1. Make the Direct Connection.
For details, refer to
2. Set the following data using LAN interface Add-
In.
• IP Address
• Subnet Mask
• Default Gateway Address
NOTE:
NWA-008862-001 Rev.2.1
ajch1001.fm
LAN Connection
LAN Connector
LAN Cable
(10BASE-T/
100BASE-TX)
The MP program downloading is not
available on LAN connection.
"Direct
Page 6
When the system was initialized by "B" (All
Clear), the following IP address and subnet
mask are set as a fixed value. Therefore you
can connect your PC to the PBX via the
LAN, even if you make your PC Direct
Connection (RS-232C connection) and do
not set an IP address using office data.
IP Address : 192.168.1.36
Subnet Mask : 255.255.255.0
[Series 3300 software (R8 software)
or later required]
CHAPTER 1 MATWorX
2. Hardware Connections
LAN
HUB/Router
PC
Connection".
Page 11