3.21 Problems On Power Saving Feature; Schedule Is Disabled [Ip8800/S6700] [Ip8800/S6600] - NEC IP8800/S2400 Series Troubleshooting Manual

3.21 Problems on Power Saving Feature

3.21.1

Schedule Is Disabled [IP8800/S6700] [IP8800/S6600]

If schedule is disabled, follow the instruction shown below.
1. Check to see if the current time is included in the displayed schedule by using the show power-control
schedule command, and isolate the problem according to the table below.
Table 3-69: Problems and Actions When Using Power Saving Feature with Power Saving Feature
No. Display of Result
1 Current time is not
included
2 Current time is
included
3
4
Confirmation
Check to see the setting by
configuration command
schedule-power-contro
l time-range
Check to see if the feature
specified by configuration
command
schedule-power-contro
l and the feature specified
during normal hours both are
not matched. If it is same, see
the Cause and Action.
Using the show system
command, check to see if
"changing suspended" appears
in the status of BSU/PSP. If so,
see the Cause and Action.
Using the show logging
command, confirm that there is
no change on the system time
within 30 minutes before the
start and end times of the
schedule.
3.
Troubleshooting Functional Failures in Operation
Cause
The setting by
• Specify the time including the current
configuration command
time if not.
schedule-power-c
• If an entry including the current time is
ontrol time-range
set to disabled, delete the entry that is
is incorrect.
set to disabled.
The features assigned by Check to see the setting of the
configuration command configuration command
schedule-power-c schedule-power-control.
ontrol is already
operating.
The shortage of the To control the power of BSU/PSP, make
number of operating redundant configuration of BSU/CSU.
BSUs/PSPs occurs. For information on redundant
configuration, see the manual
"Configuration Settings."
Schedule error caused by Wait for a while because the schedule will
system time change start within 30 minutes. For notices
occurs. regarding time change, see the manual
"Configuration Settings."
Action
123