Exit Wireless Setup; Customize Thermostat (Installer Setup) - Honeywell redlink Installation Manual

RedLINK™ Installation Guide (TrueZONE™)

Exit wireless setup

3
Press at the wireless adapter to exit wireless setup (light should stop
connect
flashing).
Note: The wireles adapter will automatically exit wireless setup after 15 minutes of
inactivity.
Note: If installing more than one zone panel, you must exit wireless setup before installing an
additional zone panel.

Customize thermostat (installer setup)

4
Follow the steps below to begin installer setup. At each function screen, press
or to change the setting as desired, then press
s t
function screen.
See tables on pages 7-9 for a description of options for each function.
FAN
To begin, press and hold the
until the display changes (about 3 seconds).
Function Setting
1
Done
Back
Press done to save & exit.
69-2090EFS—07
M28485
fan and s buttons
0
Next
M28487
next
0
Done
Press s or t to change setting
(see tables on pages 7-9)
Press next
function screen
6
to advance to the next
Back
to display next
1
Next
M28498