Functional Description - Makita 6807 Instruction Manual

2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Depth adjustment
1
A
B
003557
The depth can be adjusted by turning the locking sleeve.
Turn it in "A" direction for less depth and in "B" direction
for more depth. One full turn of the locking sleeve equals
1.5 mm change in depth.
Adjust the locking sleeve so that the distance between
the tip of the locator and the screw head is approximately
1 mm (3/64") as shown in the figure. Drive a trial screw
into your material or a piece of duplicate material. If the
depth is still not suitable for the screw, continue adjusting
until you obtain the proper depth setting.
1. Locking sleeve
4
1
2
A
003558
1
2
003559
Switch action
1
2
003560
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
NOTE:
Even with the switch on and motor running, the bit
•
will not rotate until you fit the point of the bit in the
screw head and apply forward pressure to engage
the clutch.
1. Approx. 1mm
(3/64")
2. Locator
1. Approx. 1mm
(3/64")
2. Locator
1. Switch trigger
2. Lock button