Battery Installation - Makita BMR104 Instruction Manual

7. Volume/Tuning Control/Select knob
8. DC IN socket
9. AUX IN 1
10. LCD display
11. Soft bended rod antenna
12. Handle
13. Battery compartment (covering main battery pack)
14. Speaker
15. Battery compartment locker
16. Input terminal (AUX IN 2)
17. Main battery compartment
18. Micro USB port for software upgrade
19. Red indicator
The following tables indicate the operating time on a single charge.
7.2 V 9.6 V
BL7010
PA09
9050
9051
9100
9120
9100A
9102
9122
9102A
BH9020
BH9020A
9134
9135
BH9033
BH9033A
: Cluster battery
: Slide battery
WARNING:
Do not use two main batteries at the same time.
3-1. Installing or removing Slide battery cartridge (Fig. 4)
• To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click.
• If you can see the red indicator on the upper side of the
button, it is not locked completely. Install it fully until the
red indicator cannot be seen. If not, it may accidentally
fall out of the tool, causing injury to you or someone
around you.
6
Battery Cartridge Voltage
10.8 V 12 V
PA12
1250
1251
1200
BL1013 1220
1200A
1202
1222
1202A
BH1220
BH1220C
1234
1235
1235F
BH1233
BH1233C
20. Button
21. Battery cartridge
22. Supporting bar

Battery Installation

Note:
1. Pull out the battery compartment locker to release
battery compartment. (Fig. 2)
2. Insert the main battery pack to power radio. The
suitable battery packs for this radio listed as the
following table.
14.4 V 18 V
PA14 PA18
1450 1850
1452 1852
1420 BL1815
BL1415
1422 1822
BH1420
1434 1834
BH1427
1435 1835
1435F BL1830
BL1430
BH1433
• Do not use force when installing the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
• To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge or
pressing the buttons on both sides of the cartridge.
WARNING:
Do not use two main batteries at the same time.
3-2. Installing or removing Cluster battery cartridge
(Fig. 5-9)
• Pull the supporting bar to allow the battery to insert to
the terminal.
AT SPEAKER
OUTPUT =
50mW + 50mW
unit: Hour
Approx 4.5
Approx. 6.5
Approx. 10.0
Approx. 14.5
Approx. 15.0
Approx. 17.0
Approx. 18.0