Technical Problems - Kenwood KID60B12 Installation Instructions Manual

technical problems

problem
the dishwasher does not start.
The drain pump is not working
properly.
problem
detergent residue is left at the
end of the programme.
The detergent dispenser lid
cannot be closed properly.
Knocking noise in the wash
cabinet.
Smearing appears on
glassware and cutlery.
Dishes, cutlery and glasses are
not dry.
White residue is visible on
cutlery and crockery, clouding
occurs on glassware; film can
be wiped off.
Glassware is dull and
discoloured; film cannot be
wiped off.
32
technical problems
possible causes
The door is not properly
closed.
The unit is not connected to
the mains.
The unit is not switched on.
The anti-flooding system has
operated.
general problems
possible causes
The detergent slot was still
damp when detergent was
added.
Clogged detergent residue is
blocking the catch.
A spray arms is knocking
against an item in a basket.
The rinse aid dosage is set too
high.
The amount of rinse aid may
be insufficient, or the rinse aid
reservoir is almost empty.
Crockery was taken out of the
dishwasher too soon.
Not enough rinse aid was
used.
There is not enough salt in the
salt reservoir.
The salt reservoir cap has not
been screwed on correctly.
Unsuitable detergent has been
used.
The glassware is not
dishwasher proof. The surfaces
are affected.
remedy
Close the door firmly.
Insert the plug to the mains.
Press the ON/OFF button and
select a programme.
• Disconnect from the mains.
• Disconnect the water inlet.
• Call a qualified technician.
remedy
Make sure the slot is dry before
adding detergent.
Clean the catch.
Interrupt the programme, and
rearrange the items which are
obstructing the spray arm.
See the section "Loading the
dishwasher".
Adjust the dial of the rinse aid
dispenser to a lower setting.
Replenish the reservoir, adjust
the rinse aid dispenser dial to
a higher setting or change the
brand of rinse aid.
Leave the crockery in the
dishwasher until you hear the
audible sound.
Replenish the reservoir, adjust
the rinse aid dispenser dial to
a higher setting or change the
brand of rinse aid.
Fill the salt reservoir.
Ensure that it screws back on
correctly.
Change your detergent. Use a
dishwasher standard powder
detergent or tablet.
Wash the non-dishwasher proof
glassware by hand instead.