Adding Salt - Kenwood KID60B12 Installation Instructions Manual

adding salt

If the water in your area is hard, deposits will form on your dishes and utensils. This appliance
contains a salt reservoir for you to reduce the hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir. It must be set to correspond to
the water hardness level in your area.
1. Remove the lower basket and unscrew the reservoir cap.
2. Pour in approximately 1 kg to 2 kg of dishwasher salt.
3. Fill the reservoir with water until it overflows (first use only).
4. Clean any excess salt from around the reservoir opening and
then screw the cap on again firmly.
5. Run the "Rinse" programme P8 immediately (without any
crockery in the dishwasher) to remove any traces of salt from
the compartment.
• The salt low warning indicator on the control panel will
illuminate when the reservoir is running out of salt and
requires refilling.
• The salt low warning indicator will cease to illuminate
within a few days, depending on how quickly the salt
dissolves.
* All images are for reference only; please refer to your individual unit for actual item.
18
open
open
open