Starting A Wash Cycle; Changing A Programme; At The End Of A Programme - Kenwood KID60B12 Installation Instructions Manual

starting a wash cycle

1. Ensure the unit is connected to the mains power and the water supply is on (water pressure
between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the lower and upper baskets, load the dishes and push the baskets
back. It is recommended that the lower basket is loaded first, and then the upper basket.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close firmly
afterwards.
4. Press the ON/OFF button.
5. Select the wash cycle programme based on the loading and soil requirements. Please refer to
the section "Wash Cycle Table".
6. The display will indicate the selected programme.
7. Close the dishwasher door. A click should be heard when the door is closed correctly. Do not
slam the door.
8. The washing cycle will begin shortly.
If you open the dishwasher door during the washing cycle and then close it, the dishwasher
will continue the current washing programme after 10 seconds.

changing a programme

To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has
dispensed the detergent or detergent tablet. This will depend on how long the washing cycle was
running for. The last selected programme will appear on the window display.
2. If the detergent dispenser lid is opened, we suggest that you allow the wash cycle to finish.
3. If the detergent dispenser lid is still closed, press and hold down the P button for 3 seconds to
cancel the programme. End of program indicator flashes and the display window shows "1". You
can then select the required new programme button and close the dishwasher door. The unit will
start the new washing cycle shortly.

at the end of a programme

At the end of the programme, the dishwasher will beep and the end of program indicator will turn on.
The condensation strip helps to prevent the risk of steam damage to the worktop edging
above the dishwasher, it is advisable to leave the door closed until you are ready to unload
the crockery. However, you can also open the dishwasher door fully and wait until the
dishes and crockery are cool enough to unload. Do not leave the door only partially open.
26