Configuring For Tcp/Ip - Motorola SURFboard SB4100 User Manual

R
Introduction Before You Begin Installation Operation
The SB4100 contains all necessary software.
You don't need to configure the SB4100 but
you must configure your computer for TCP/IP
(software protocol developed for communica-
tion between computers) and check for an
IP address. Your service provider may provide
additional instructions for setting up your
computer.

Configuring for TCP/IP

The following basic instructions are for
Windows 95 or Windows 98. If you are using
a different operating system, refer to that
user guide.
1
On the Windows Desktop, click Start.
Select Settings and then Control Panel
2
from the pop-up menus.
Basic Configuration
Double-click the Network icon on the
3
Control Panel window.
Select the Configuration tab on the
4
Network window for Windows 95
or Windows 98.
Check to see if TCP/IP has been
5
installed for the device being used
(Ethernet card or USB). If TCP/IP
appears in the list of network
components, it is installed and
you can proceed to step 10. If it
doesn't appear on the list, continue
with step 6.
11
Troubleshooting
TM