Boot Cycle - Motorola DCT3080 Installation Manual

Boot Cycle

After connecting the proper cabling to the DCT3080, plug the power
cord into the DCT3080 and electrical wall outlet. Begin performing the
boot cycle procedure:
After a few moments, the LED displays HUNT and then FR 1.
The DCT3080 searches for the headend out-of-band (OOB)
frequency carrier. If the OOB frequency is not set to 75.25 MHz, the
LED flashes FR 1 and then flashes FR 2. This searching process
repeats until the correct OOB frequency is found and the required
message for the DCT3080 model is acquired.
The LED displays and OOB frequencies are:
Table 2-4
LED displays and OOB frequencies
Display Frequency
dl
N/A
EF
N/A
FP
N/A
____
N/A
Hunt
N/A
FR 1
75.25
MHz
FR 2
104.20
MHz
FR 3
72.75
MHz
FR 4
92.25
MHz
FR 5
98.25
MHz
FR 6
103.75
MHz
Description
OOB network download in progress
Erasing Flash memory
Flash memory is being programmed
Network download complete
Hunting for OOB frequency
Attempting to lock on frequency 1
Attempting to lock on frequency 2
Attempting to lock on frequency 3
Attempting to lock on frequency 4
Attempting to lock on frequency 5
Attempting to lock on frequency 6
32
DCT3080 Installation Manual