Connect the Ring Scanner (Optional)
1. Slide the ring scanner cable connector into the bottom of the sled until the
connector ring clicks shut.
It is not necessary to remove the ring scanner from the sled before
removing the Dolphin 70e Black from the sled.
2. When connected to a terminal that is powered up, the terminal emits 3
beeps and the ring scanner LED blinks green one time.
Note: When connecting the 8620 Ring Scanner you must have ScanWedge
NGW running and a scanning application open on your terminal to be
able to scan a bar code. See
Attaching the Ring to your Finger
1. Remove shipping film off the scanner window.
2. Slide finger into loosened ring strap.
3. Pull ring strap to secure ring to finger.
Note: If using the C-ring simply slide on to finger.
The ring scanner has a built-in quick disconnect designed for occasional safety hazards. It is not intended for frequent, nor-
mal removal of the ring scanner from the hand.
Do not touch, push against or brace your finger on the scan aperture at any time.
Trigger Rotation
The scanner head can be rotated 180° to be work on the right or left hand.
ScanWedge NGW
on page 4-2.
2 - 9