Table of Contents
Advertisement
. The first unit will then turn on the microphone and the second unit will turn on
earpiece to monitor sound.
NOTE: Handsets can be on cradle or off cradle for room monitoring to
work.
NOTE: While in room monitoring mode, the listening unit will emit an
alert tone approximately every 4 seconds if there is an incoming call.
You may press the LINE 1 or LINE 2 button to quit room monitor and
answer the call.
NOTE: Press the CANCEL (SKR) or the END/CANCEL button to exit room
monitor mode.
Call Transfer
During an external call, you may transfer the external call from base to handset(s)
or vice versa.
NOTE: To cancel the call transfer, you may press END/CANCEL button or
int button on base.
1. Press the int button to put the line on hold. LX ON HOLD shows in the display, where X
is the Line number.
. Use the 5 or 6 buttons to select the desired handset or base. Press the SELECT (SKL)
to confirm.
NOTE: If you only have one handset registered in the system, it is
paged automatically.
. Press the END/CANCEL button to transfer the call. TRANSFERRING FROM XXXX (where
XXXX is the name of the transferring unit) shows in the receiving unit's display.
4. Press the OK (SKL) on the receiving unit to answer the call.
NOTE: If there is no answer within 2 minutes after transferring the call,
then both units receive a call back notification. If neither unit answers
within 30 seconds, then the external call will be automatically dropped.
Push to Talk
This feature allows you to directly talk to another registered handsets or base by pressing
the PUSH TO TALK button on either handset or base respectively.
1. Make sure your phone is OFF (not in TALK mode).
. Press the PUSH TO TALK button on base or handset.
. A list of registered handsets and base shows on the display.
4. Use the 5 or 6 button to desired handset or base. The default setting at base is
HANDSET 1 and the default setting at handset is BASE.
Advertisement
Table of Contents
