Carriage Encoder Sensor Removal - Epson DFX-8500 Service Manual

3.2.6.21 Carriage Encoder Sensor Removal

1. Remove the printhead. (See Section 3.2.2.)
2. Disconnect the carriage encoder sensor connector (red, 4 pins) from the carriage connector junction
board. (See Figure 3-78.)
3. Remove 2 screws (CP (S-P1), M2.6×5) securing the carriage encoder sensor to the carriage, then
remove the sensor. (See Figure 3-79.)
Carriage Encoder Sensor
Figure 3-78. Disconnecting the Carriage Encoder Sensor
Screw (CP (S-P1), M2.6×5)
Carriage Encoder
Sensor
Carriage
Figure 3-79. Carriage Encoder Sensor Removal
DISASSEMBLY AND ASSEMBLY
Carriage
Red Connector, 4 pins
Carriage Connector
Junction Board
3-55