Circuit Board Removal; Bottom Panel Removal - Epson DFX-8500 Service Manual

DFX-8500

3.2.4 Circuit Board Removal

This section describes how to remove the circuit boards.

3.2.4.1 Bottom Panel Removal

Spread a thick, soft cloth under the printer before you follow the steps below.


Make sure the parallel interface cable latch is not caught between the lower case and bottom panel
when you attach the bottom panel..
1. Remove the left and right covers. (See Section 3.2.3.2)
2. On the right side of the printer mechanism, remove 1 screw (CBS (O), M4×8) securing the green and
yellow ground cable to the ground plate.
Ground Cable
C204 PSB/PSE
Board
Figure 3-23. Connector and Ground Cable Removal (right side)
3-18
CAUTION
Bottom Panel
Assembly
(Right side)
Screw (CBS (O), M4×8)