Yamaha HTR-6150 Service Manual page 22

RX-V563/HTR-6150/DSP-AX563
I SELF-DIAGNOSTIC FUNCTION
This unit has self diagnosis functions that are intended for inspection, measurement and location of faulty point.
There are 19 main menu items, each of which has sub-menu items.
Listed in the table below are menu items and sub-menu items.
Note that not all menu items listed will apply to the models covered in this service manual.
No. Main menu
A BYPASS 1 ANLOG BYPAS
2 DSP BYPASS
B AUDIO CHECK 1 AUDIO CHECK
2 ANALOG AUDIO PLAYBACK
3 MUTE ALL
4 MUTE SYS IC
5 MUTE TR
C SPEAKERS SET 1 FRNT : SML0dB
2 CENTER : NONE
3 LFE/B : FRNT
4 TONE : MAX
5 TONE : MIN
D XCH-INPUT 1 6chINPUT 6Ω
2 8chINPUT 6Ω
3 6chINPUT 8Ω
4 8chINPUT 8Ω
5 LIM : PLDET : THM
E MIC CHECK 1 MIC CHECK
F FL/OSD CHECK 1 VFD CHECK
2 VFD DISP OFF
3 VFD DISP ALL
4 VFD DIMMER
5 CHECK PATTERN
G TEST TONE 1 TEST ALL
2 TEST FRNT L
3 TEST CENTER
4 TEST FRNT R
5 TEST SURR R
6 TEST SURB R
7 TEST SURB L
8 TEST SURR L
9 TEST LFE
H XM STATUS 1 1k – 1dB/44
(U, C models) 2 1k –61dB/44
3 MUTE
4 XM TONE/44
5 ISO TONE/44
6 1k – 1dB/32
7 1k –61dB/32
8 MUTE
9 XM TONE/32
10 ISOTONE/32
11 BUSPWR (BUS power) : OFF
I iPod 1 DOCK : xx xxx
2 DOCK IGNORE
3 Bluetooth version
4 Clear Bluetooth pairing info.
J USB 1 USBFile1/xx
(R, T, K, A, B, G, E, F, L models) 2 USBFile2/xx
3 High Speed TEST_PACKET mode
4 High Speed TEST_SE0_NAK mode
K SIRIUS 1 SIRIUS connection check
(U, C models) 2 SIRIUS antenna status
3 SIRIUS loop back test
4 SIRIUS SSP version display
5 SIRIUS firmware #1 version display
6 SIRIUS Firmware #2 version display
7 SIRIUS FW product_id version display
8 SIRIUS FW sequence_id version display (only for SIRIUS certification engineer)
22
Sub-menu
(ex. D5.255:255: 64)
/44
/32
(only for SIRIUS certification engineer)
(only for SIRIUS certification engineer)
(only for SIRIUS certification engineer)
(only for SIRIUS certification engineer)
No. Main menu
L VIDEO CONVERSION 1 V–IN (Video info.)
2 V–CONV S–V (Conversion S-video)
3 V–CONV CVBS (Conversion CVBS)
4 V–CONV OFF (Conversion OFF)
5 V–TestPttrn (Video test pattern)
M HDMI Check 1 HDMI SPDIF (SPDIF audio playback)
2 HDMI NONE
3 HDMI IN1
4 HDMI IN2
5 I2C : xx xxx (I2C access check)
6 Model ID for EDID setting
N AD DATA CHECK 1 PD : xxx DI : xxx
2 V1 : xxx V2 : xxx
3 TH : xxx PL : xxx
4 PI : xxx DE : xxx
5 K0 : xxx K1 : xxx
O PROTECTION 1 PRD : xxx/xxx
2 PV1 : xxx/xxx
3 PV2 : xxx/xxx
4 THM : xxx/xxx
5 L66 : xxx/xxx (PLDET 6ch 6ohms : xxx/xxx)
6 L86 : xxx/xxx (PLDET 8ch 6ohms : xxx/xxx)
7 L68 : xxx/xxx (PLDET 6ch 8ohms : xxx/xxx)
8 L88 : xxx/xxx (PLDET 8ch 8ohms : xxx/xxx)
9 PRI : xxx/xxx (PRI : xxx/xxx)
10 PDE : xxx/xxx (PDET : xxx/xxx)
P PROTECTION HIST. 1 History 1
2 History 2
3 History 3
4 History 4
Q RESERVED
R FACTORY PRESET 1 PRESET INHI
2 PRESET RSRV
S ROM VER/SUM 1 Microprocessor version
2 All checksum
3 Program checksum
4 SPI checksum
5 SPD checksum
6 XM version (U, C models)
7 SIRIUS version (U, C models)
8 FlashROM test
9 SDRAM test
10 EEPROM test
Sub-menu
(ex. N1PD: 45DI: 0)
(ex. N2V1: 94V2:128)
(ex. N3TH: 64PL:255)
(ex. N4PI: 0DE: 0)
(ex. N5K0:254K1:254)
(ex. O1.PRD: 23/ 70)
(ex. O2.PV1: 68/161)
(ex. O3.PV2:104/181)
(ex. O4.THM: 0/131)
(ex. O5.L66: 0/ 0)
(ex. O6.L86: 0/ 0)
(ex. O7.L68: 0/ 0)
(ex. O8.L88: 0/ 0)
(ex. O9.PRI: 0/100)
(ex. O10PDE: 0/255)
(ex. PRV:xxx)
(ex. THM:xxx)
(ex. PRI:xxx)