Advertisement
Lubrication
This tool requires no hourly or daily lubrication because it has a grease-packed lubrication
system. Lubricate the tool every time the carbon brushes are replaced.
Run the tool for several minutes to warm it up. Switch off and unplug the tool. Remove
the crank cap using a Makita lock nut wrench (optional accessory). Rest the tool on the
table with the bit end pointing upwards. This will allow the old grease the collect inside
the crank housing. Wipe out the old grease inside and replace with a fresh grease (30 g;
1 oz). Use only Makita genuine grease (optional accessory). Filling with more than the
specified amount of grease (approx. 30 g; 1 oz) can cause faulty hammering action or tool
failure. Fill only with the specified amount of grease. Reinstall the crank cap and tighten
with the lock nut wrench. Do not tighten the crank cap excessively. It is made of resin
and is subject to breakage.
Lock
nut wrench
Y ! /
10
Advertisement
