D-Link DNS-313 User Manual page 12

Section 2 - Installation
5. Move the Direct Attached/Network Storage Mode
switch to the Network Storage Mode position and
connect an Ethernet cable to the Ethernet port. This
cable should connect the DNS-313 to your local
network via a router or switch, or directly to a computer
for configuration.
6. Connect the power adapter to the power receptacle.
Note: When a new hard disk is installed, the hard disk
must be formatted in the DNS-313 before it can be
used. Insert the Installation CD into your computer's
CD-ROM or DVD-ROM drive and follow the instructions
in the "Setup Utilities" section on page 10 to use the Click
n' Connect Utility for initial setup.
D-Link DNS-313 User Manual 9