Enabling Or Disabling Aux Bus Control; Selecting The Mode For Turning Off Keys Upon Receiving The Editor Command - Sony MVS-3000 System User Manual

4
Select the pulse width and timing to be set.
No. Parameter
3 Pulse Width Pulse width
4 Timing
a) 1: Field 1, 2: Field 2, 3: Any
When " " is selected as the trigger polarity, there is
no Pulse Width setting. When "Status" is selected,
there is no Pulse Width or Timing setting.
5
In the <Source> group, select the action block.
M/E-1 and P/P: Sets an action for the M/E or PGM/
PST bank.
Common: Sets an action for error status.
6
Select the action to be set.
7
Press [Action Set] to confirm the action selection.
Selectable actions for various trigger types
• When the trigger type is other than "Status"
(The x in M/E-x is the M/E bank number, the x in DSKx
is the DSK number, and the x in Keyx is the key
number).
When Source is M/E-x: Cut, Auto Trans, Keyx Cut,
Keyx Auto Trans, Keyx SS ? Recall, Effect ? Recall,
Effect ? Recall & Run, KF Run, KF Stop, KF
Rewind, No Action
When Source is P/P: Cut, Auto Trans, DSKx Cut, DSKx
Auto Trans, FTB Cut, FTB Auto Trans, DSKx SS ?
Recall, Effect ? Recall, Effect ? Recall & Run, KF
Run, KF Stop, KF Rewind, No Action
When Source is Common: No Action
• When the trigger type is "Status"
(The x in M/E-x is the M/E bank number, the x in DSKx
is the DSK number, and the x in Keyx is the key
number).
When Source is M/E-x: Keyx On, No Action
When Source is P/P: DSKx On, No Action
When Source is Common: Error Make, Error Break, No
Action
Test firing the trigger
Press [Test Fire].
This outputs a trigger from the selected output port. This is
no output when the trigger type is "Status."
Enabling or Disabling AUX Bus
Control
1
In the Engineering Setup >Switcher >Device Interface
menu (7337), press [AUX Control].
256
Interfacing with External Devices
Adjustment
a)
Output timing
The AUX Control menu (7337.5) appears.
2
Select the 9-pin port for the setting from the <Control>
group.
Remote S1: Makes the settings for the Remote S1
port.
Remote S2: Makes the settings for the Remote S2
port.
3
Select the AUX bus.
4
Select whether to enable or disable AUX bus control
from the <Control Mode> group.
Enable: Enables control of the port selected in step 2.
Disable: Disables control of the port selected in step 2.
Manual: Sets whether control of the port selected in
step 2 is possible or not depend on the setting in
the Misc menu.
5
Repeat steps 2 to 4 as required to make the settings for
other ports.
Selecting the Mode for Turning Off
Keys upon Receiving the Editor
Command
Selects the mode for turning off keys when an "All Stop"
command is received from the editor.
1
In the Engineering Setup >Switcher >Device Interface
menu (7337), press [Editor I/F].
The Editor I/F menu (7337.8) appears.
2
Select one of the following modes.
All: When an "All Stop" command is received, all
keys for the selected regions are turned off.
Specified: When an "All Stop" command is received,
among all the keys for the selected regions, only
the keys specified by the editor are turned off.
Notes
When an "All Stop" command is received in the
process of a transition, the keys selected for the next
transition are also turned off.