Sharp AR-C150 Service Manual page 8

AR-C150
B. Developer setup
(1) Developer setup
1) Remove the blue screw (1), and remove the DSD holder
(2)(3)(4)(5).
5
4
1
(Note) A color label is attached to each DSD holder for identification
of the color. When installing the DSD holders, be sure to
match the label color with the color on the machine.
2) Remove the special tool (2) from the back of the process cover
(1).
1
3) Fix the drum holder (4) with the special tool (2), and remove the
blue screw (3).
2
4
3
3
2
2
4
4) Pull out the transfer unit, cover the whole surface of the transfer
belt with paper, and insert the transfer unit. At that time, keep
the lock handle released. This procedure is performed in order to
prevent against dirt by toner dropped from the process frame
unit.
5) Remove the connector (1) and loosen the blue screw (2).
1
6) Remove the process frame unit from the arrow section.
7) Set the developer units in the sequence of (1) to (4).
(Note) Insert section A into the hole along the arrow indication.
Fit the projection B with the hole in the developer unit, and
connect the connector C.
Set each developer unit to its position. Be careful not to mis-
take the position.
A
4 – 9
2
4 (Y)
3 (M)
2 (C)
1 (K)