Toro Workman MDX-D Service Manual page 74

1. Gear 34
2. Counter shaft
F. Apply molybdenum disulfide grease to the inside
of gear 34 and the contact surface between the case
and the counter shaft.
6. Assemble case (LH and RH).
1. Case (sealing surface)
A. Make sure gasket sealing surfaces of both cases
are clean. Install gasket to case.
Drive Train
1
Figure 53
1
Figure 54
Page 4 - - 40
2
3
3. Spacer
G. Place gear 34 onto the spacer. Make sure not to
drop the spacer. Insert needle bearing into gear. In-
sert counter shaft with remaining spacer through the
needle bearing, gear 34 and into the spacer and
case.
2. Pipe knock
B. Install both pipe knocks to the case (LH).
2
Workman MDX--D