Chapter 4 - - Drive Train; Engine Clutch Adapter - Toro Workman MDX-D Service Manual

Engine Clutch Adapter

RIGHT
FRONT
1. Drive belt
2. Cap screw
3. Flange washer
Removal (Fig. 17)
1. Park machine on a level surface, stop the engine, en-
gage parking brake and remove the key from the ignition
switch.
2. Raise and support cargo bed to access engine.
3. Carefully remove drive belt from drive clutch.
4. Remove drive clutch from clutch adapter on engine
(see Drive Clutch in the Service and Repairs section of
Chapter 4 -- Drive Train).
5. Remove five (5) cap screws that secure clutch
adapter to engine flywheel. Remove clutch adapter from
engine.
Diesel Engine
7
6
5
4
Figure 17
4. Drive clutch
5. Cap screw (5 used)
Installation (Fig. 17)
1. Position clutch adapter to engine flywheel and se-
cure with five (5) cap screws.
2. Secure drive clutch to clutch adapter on engine (see
Drive Clutch in the Service and Repairs section of
Chapter 4 -- Drive Train).
3. Install drive belt to drive clutch.
4. Lower and secure cargo bed.
Page 3 - - 18
17 to 22 ft- -lb
(23 to 29 N- -m)
1
Loctite #242
3
2
6. Clutch adapter
7. Engine assembly
Workman MDX--D