Toro Workman MDX-D Service Manual page 62

1. Input shaft
B. Replace input shaft if worn or damaged. Gear
teeth that are cracked, broken, chipped or missing
are not acceptable.
5. Disassemble center shaft assembly.
1. Ball bearing
IMPORTANT: Do not reuse ball bearings that have
been removed.
Drive Train
2
1
2
Figure 32
2. Ball bearing
C. Ball bearing roller balls must be free of deforma-
tion and scoring. Ball bearing must spin freely and
have minimum axial play. Replace ball bearing as
necessary.
1
Figure 33
2. Ball bearing
A. Remove ball bearings from the center shaft as-
sembly. Discard removed bearings.
Page 4 - - 28 Workman MDX--D