Connect Your Cable Modem To A Router After Installation And Activation - NETGEAR CM600 User Manual

If your actual speed is lower than your subscribed speed, contact your cable Internet
provider.
Connect Your Cable Modem to a Router After Installation
and Activation
During the installation and activation, you must connect the cable modem directly to a
computer. After installation and activation, you can connect the cable modem to a router.
Coaxial cable to
cable outlet
Power adapter
Figure 7. Connect the cable modem to a router

To connect your cable modem to a router after installation and activation:
1. Reboot the cable modem by unplugging the power cable from the cable modem and
plugging it back in.
Note: Do not disconnect the cable modem from the cable outlet.
When the startup procedure is completed, the Power LED lights green
Wait for the Internet LED to stop blinking and light solid green
2. Use an Ethernet cable to connect the Ethernet port on the cable modem to the WAN or
Internet port on the router.
3. Power on the router.
Wait until the router is ready.
4. Connect a computer to the router over a WiFi connection or through an Ethernet cable to a
LAN port on the router.
CM600 Cable Modem
Ethernet cable
Cable modem
DRAFT
Hardware and Internet Setup
Router
12
Computer connected
to the router over
WiFi or Ethernet
.
.