Mx-Smx1 (256Mb Expansion Memory Board) - Sharp MX-2300 G Installation Manual

[21] MX-SMX1 MX2700N
1. Unpacking
A. Parts included
256MB expansion memory
2. Installation
A. Installation of the expansion memory
1) Turn OFF the main switch of the copier, and disconnect the
power plug of the copier from the power outlet.
2) Remove the screw, and remove the rear cabinet.
3) Remove the connector and the screw, and remove the MFP
PWB shield plate upper.
2
4) Install the expansion memory to the connector.
2
1
3
1
MX-2300/2700 N/G MX-SMX1 21 – 1
* Note for installing the expansion memory
a) Push the sections indicated with
both hands.
* When handling the expansion memory, be careful not to
touch the pin section.
* Insert the memory straightly until it comes in contact
with the contact.
* When inserting, be careful not to slant the memory for
the connector. Do not push the memory by one hand
alone.
b) Push the sections indicated with
both hands until the right and the left buttons are locked.
5) Install the MFP PWB shield plate upper, and connect the con-
nector.
1
at the same time with
at the same time with
2