Ar-Pf1 (Barcode Font Kit) - Sharp MX-2300 G Installation Manual

: Dec. 15 2005
1
[13] AR-PF1
MX2700N
1. Unpacking
A. Parts included
AR-PF1 barcode font ROM PWB
1
1
No. Packed part names
1 CD-ROM
2 Operation Manual
2. Installation
A. Installation of the barcode font ROM PWB
1) Turn OFF the main switch of the copier, and disconnect the
power plug of the copier from the power outlet.
2) Remove the screw, and remove the rear cabinet.
3) Remove the connector and the screw, and remove the MFP
PWB shield plate upper.
2
2
Quantity
1
1
2
1
1
MX-2300/2700 N/G AR-PF1 13 – 1
4) Install the barcode font ROM PWB to the barcode connector.
* Check to confirm that the silver push lever extends out when
the PWB is installed.
* The connector position is indicated by the silk print on the
PWB.
BOOT
PROGRAM
PCL/BUMON
BARCODE
FAX IMG EXT
PS KANJI
5) Install the MFP PWB shield plate upper and connect the con-
nector.
1
6) Install the rear cabinet.
7) Insert the power plug of the copier into the power outlet. Turn
ON the power switch and perform the following procedures.
B. PCL expansion font list check
1) PCL expansion font list check
Select the PCL expansion font list by the procedures described
in the printer test page in the system setup guide.
Check to confirm that the barcode font list is printed.
2
1
2