Table of Contents
Advertisement
ENGLISH (Original instructions)
SPECIFICATIONS
Capacities
-1
No load speed (min
Impacts per minute (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Cd
Only for EU countries
Ni-MH
Do not dispose of electric equipment or
Li-ion
battery pack together with household
waste material!
In
observance
Directives, on Waste Electric and
Electronic Equipment and Batteries and
Accumulators and Waste Batteries and
Accumulators and their implementation
in accordance with national laws,
electric equipment and batteries and
battery pack(s) that have reached the
end of their life must be collected
separately
environmentally compatible recycling
facility.
Intended use
The tool is intended for fastening bolts and nuts.
Noise
The
typical
A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Model
Standard bolt
High tensile bolt
Square drive
Impact mode (Hard)
)
Impact mode (Medium)
Impact mode (Soft)
Impact mode (Hard)
-1
)
Impact mode (Medium)
Impact mode (Soft)
Overall length
Net weight
Rated voltage
of
the
and
returned
noise
level
determined
) : 96 dB (A)
pA
) : 107 dB (A)
WA
M10 - M20
M10 - M16
D.C. 14.4 V
END004-6
Vibration
The
vibration
determined according to EN60745:
Model DTW280
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
European
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DTW281
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
to
an
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENE036-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENG905-1
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
2
DTW280
12.7 mm
0 - 2,800
0 - 2,100
0 - 1,600
0 - 3,500
0 - 2,600
0 - 1,800
147 mm
1.5 kg
Wear ear protection
total
value
) : 14.0 m/s
h
2
) : 11.5 m/s
h
2
DTW281
M10 - M20
M10 - M16
12.7 mm
0 - 2,800
0 - 2,100
0 - 1,600
0 - 3,500
0 - 2,600
0 - 1,800
147 mm
1.7 kg
D.C. 18 V
ENG900-1
(tri-axial
vector
sum)
2
2
ENG901-1
Advertisement
Table of Contents
