Network Configuration
Setting up the Network Configuration
Follow the procedure below if your network is not configured with the DHCP server, and the TCP/IP parameters must be set
up manually.
- IP Address
- Subnet Mask
- Default Gateway
- DNS Server
Before executing the procedures
described below, make sure the Print
On Line LED is lit.
1
Press the Function key.
Print On Line LED
●
Wait until the Print On Line LED lights up
before pressing the Function key.
2
Select "General Settings".
3
Select "09 Key Operator Mode".
1
4
Function key
2
4
Enter the Key Operator's password
(8 digits), and then select "OK".
1
●
The default password is "00000000".
To change the password, select "85 Key
Operator Password" in the General
Settings (Key Operator Mode), and then
enter the new password.
5
Select "04 Network Settings".
2