Change Channel Control - Cisco AT6400 User Manual

UNIVERSAL REMOTE CONTROL
After you press the ENTER key, the volume keys control the device assigned to that mode. For
example, in TV mode, the volume keys control volume for the TV only.
NOTES:
• If any other key is pressed except the Mode keys and the ENTER key, the remote does not
accept any changes or updates. The STB mode key displays a long red flash and the remote
returns to normal operation.
• If the remote times out before you complete programming volume control, the remote does
not accept any changes. You must start over from step 1 of this procedure.

11. CHANGE CHANNEL CONTROL

The remote is set by default to control channel selection on the Set Top Box. You can also program
channel control to control any of the TV, DVD, or AUX mode devices provided the device allows for
channel control assignment. Or, you can set the channel selection control programming to control
channels (or page up or down) for all of the devices programmed in the four mode keys. Otherwise,
you can only control channels (or page up or down) on a specific device, for example, the TV or DVD.
NOTE: The channel control keys include CH/Page, Jump, and the numeric keys 0-9.
CONTROLLING CHANNELS FOR ONE DEVICE (Program Code 966)
1. Press and hold the STB mode key on the remote control.
2. Without releasing the STB key, press and hold the OK key.
3. Release both keys and all mode keys blink twice.
4. Enter the programming code 966 by pressing the numeric keys on the remote. The STB mode
key blinks twice to indicate a successful entry.
5. Press and release the mode key for the device you want the channel key to control. For
example, if you want to control channels on your TV, press and release TV. The selected mode
key blinks three times to indicate a successful entry.
The channel key now always controls the device associated with the mode you selected in this
procedure, whether in STB, TV, DVD, or AUX mode.
CONTROLLING CHANNELS FOR DIFFERENT DEVICES (Program Code 966)
Complete steps 1 through 4 of the Controlling Channels for One Device procedure.
Press and release the ENTER key. The STB mode key blinks three times to indicate a successful entry.
8