D-Link DES-1228 Reference Manual page 49

Example usage:
To delete an SNMP host entry:
DES-1228/ME:4#delete snmp host 10.48.74.100
Command: delete snmp host 10.48.74.100
Success.
DES-1228/ME:4#
show snmp host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the currently configured SNMP hosts on the Switch:
DES-1228/ME:4#show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address
---------------
10.48.76.23
10.48.74.100
Total Entries: 2
DES-1228/ME:4#
create trusted_host
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to display the recipient of SNMP traps generated by the Switch's SNMP agent.
show snmp host {<ipaddr>}
The show snmp host command is used to display the IP addresses and configuration
information of remote SNMP managers that are designated as recipients of SNMP traps
that are generated by the Switch's SNMP agent.
<ipaddr> − The IP address of a remote SNMP manager that will receive SNMP traps
generated by the Switch's SNMP agent.
None.
SNMP Version
---------------------
V2c
V3
Used to create the trusted host.
create trusted_host <ipaddr>
The create trusted_host command creates the trusted host. The Switch allows users to
specify up to ten IP addresses that are allowed to manage the Switch via in-band SNMP or
TELNET based management software. These IP addresses must be members of the
Management VLAN. If no IP addresses are specified, then there is nothing to prevent any
IP address from accessing the Switch, provided the user knows the Username and
Password.
<ipaddr> − The IP address of the trusted host to be created.
Only Administrator-level users can issue this command.
Community Name/SNMPv3 User Name
------------------------------
authpriv
44
private
public