D-Link DES-1228 Reference Manual page 117

show cos mac_mapping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the MAC address to traffic class mapping of MAC address 00-01-02-03-04-05:
DES-1228/ME:4# show cos mac_mapping destination_addr 00-01-02-03-04-05
Command: show cos mac_mapping destination_addr
MAC Address
---------------------------------------
00-01-02-03-04-05
DES-1228/ME:4#
config cos tos value
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Configure the TOS 5 to the traffic class 1 mapping:
DES-1228/ME:4# config cos tos value 5 class 1
Command: config cos tos value 5 class 1
Success.
DES-1228/ME:4#
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to show the mapping between destination MAC addresses and CoS traffic classes.
show cos mac_mapping {destination_addr <macaddr>}
The show cos mac_mapping command display the information of the destination MAC
address mapped to a traffic class.
destination_addr − The MAC address of the incoming packet destination address. If no
parameter is specified, all the MAC address mapping to traffic class will be shown.
None.
Class
2
Used to map the ToS value in the IP header of incoming packets to one of the eight
hardware queues available on the switch.
config cos tos value <value 0-7> [class <class_id 0-3>]
The config cos tos command is used to configure ToS to traffic class mapping.
<value 0-7> − The ToS value of incoming packet that you want to associate with the traffic
class.
<class_id 0-3> − The number of the Switch's hardware priority queue. The Switch has four
hardware priority queues available. They are numbered between 0 (the lowest priority)
and 3 (the highest priority).
Only Administrator-level users can issue this command.
00-01-02-03-04-05
112