Chapter 5 System Settings and Display
5.2 Network Management > show network
show network
This command displays the network (LAN) configuration parameters.
■
Syntax
show network
■
Parameter
No parameters.
■
Output
MNT port
RMT port
FST port
Ipv4
Master IP Address
Slave IP Address
Subnet Mask
Gateway
Primary DNS
Secondary DNS
Speed and Duplex
Maintenance port (MNT port) name
Remote port (RMT port) name
Field support port (FST port) name
(This information is not supported in ETERNUS DX100 S3/DX200 S3 and the ETERNUS DX200F.)
Indicates whether IPv4 settings are enabled or disabled (Enable/Disable/Factory Default)
(When the factory default network setting is set, this information is displayed as "Factory
Default" for the MNT port.)
IP address of the maintenance port on master CM (IPv4)
IP address of the maintenance port on slave CM (IPv4)
Subnet mask of the maintenance port (IPv4)
Gateway IP address (IPv4 and IPv6) of the maintenance port
Primary DNS IP address (IPv4 and IPv6)
Secondary DNS IP address (IPv4 and IPv6)
Connection speed of the maintenance port (IPv4 and IPv6)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
492
P2X0-1210-05ENZ0