Advertisement
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS []
Are these the right instructions
for your model? Follow the Installation
Instructions
indicated by
the label on the back of the refrigerator--
[] [] [] [] [] [] [] [] [] [] [] [] or []
BEFORE YOU BEGIN
Read each step thoroughly
before
proceeding.
• CAUTION
-
Unplug the
Refrigerator.
To eliminate
the danger
of electric
shock during
installation,
"_
]
you must unplug
the refrigerator
from
\\
its electrical
oudet.
,\
TOOLS YOU WILL NEED
Flatblade andPhillips
Pliers
screwdrivers
Sharp knife
PARTS REQUIRED THAT CAME
WITH THE REFRIGERATOR
Icebucket
PartNo.WR30S1
Phillipshead
Icemaker m ounting block
screws(2)
PartNo.WR2M3604
Part N o.WR1M478
[] PREPARE FOR INSTALLATION
• Remove
all freezer
baskets
for greater
accessibility
to the rear of the freezer.
• Remove
and discard
the --
large white plug from
the rear freezer
wall.
[hill out the gray
insulation
plug and
remove
any debris.
• Remove the outlet cover
with a flat-blade screwdriver.
[] INSTALL FILL TUBE
• Cut the rill tube (16) to the []
length
(refer to the []
template
on page 66) with a sharp
knife
or a single-edge
razor blade.
• Slide the fill tube (16) onto the
water tube inlet (15).
• Go to the back of the refrigerator.
Remove the label covering the
hole. Pull out the insulation plug
and any debris.
• On the tube side of the water
tube inlet (15) there is an
adhesive backing.
Remove the
adhesive backing
and slide the
tube into the hole near the top at
the back of the refrigerator. Firmly press
on the inlet to secure it to the refrigerator.
@
[] SET POWER SWITCH
TO O (off)
Set the icemaker power switch to 0 (off). Leave
the power switch in the 0 (off) position
until the
refrigerator
is connected
to the water supply to
prevent
premature
operation.
• Holefor
wiretie
Po_r
[] INSTALL THE MOUNTING
BLOCK
• Inside the freezer, remove the two small white plug
buttons
from the side wall.
• Using the Phillips head screws
c,.
o..
that are with the mounting
....
block, attach the mounting
block to the refrigerator
by
driving the screws through
the outer holes on
the block and into the holes that the plug buttons
were in.
• Install two self-tapping
Phillips
head screws (14)
from the kit in the inner holes on the mounting
block• On some models, the screws may already be
in place on the mounting
block. The screw heads
should extend
about 1/2" (13 ram) from the
mounting
block•
54
Advertisement
