GE Multilin D20E Installation And Maintenance Manual page 60

62
Setting Descriptions
Historical settings
Note: The D20E does not currently support the Historical data settings.
Calculation settings
Note: No calculation is applied on the Counter Input.
Providers - Protocol settings
Reference Specify a text string that combines the bay name,
Name group name, and provider name from the General
tab.
Physical Specify the index of the physical IO pin.
Index
Debounce Specify (in ms) the amount of time a point must stay
Filter Length in a given state before a change to state is recorded.
Chatter Filter Select the amount of time (in ms) to be used in the
Time Range Chatter Filter calculation.
Chatter Filter Specify the number of changes during the Chatter
On Trigger Filter Time period that enables the Chatter Filter.
The recommended value is 10 to 20 changes, to
reduce event noise.
Chatter Filter Specify the number of changes allowed during the
Off Chatter Filter Time period before the Chatter Filter is
Hysteresis turned off.
Pulse Count This setting must be enabled for Counter points.
Enable
Pulse Count Specify the Reset Pulse count to be value 0 (zero)
Reset when the D20E is rebooted and when the Pulse
Count Enable setting is Enabled.
Pulse Polarity Specify the state that increases the count of the
Counter point.
Physical This setting is not used for Counter points.
Index 2
Counter Type Specify the type of counter. See section:
type
on page 60.
Note: Only Binary counters should be selected. This
enables both Binary and Frozen counter types in the
Publisher for DNP3.0 Object 21 and integrity polls.
Publisher settings
Reference Specify a text string that combines the bay name,
Name group name, and provider name from the General
tab.
Point Specify the point description of the mapped analog
Description input or counter.
Value Type Specify the date type the Publisher application uses
when reporting the counter.
RTDB Point Specify the RTDB point whose value is reported for
the counter. A custom window allows you to
associate the counter to any analog input or counter
available in the D20E.
GE INFORMATION
CHAPTER 3: CONFIGURING THE D20E FIRMWARE
Range
0 (off) to 1000.ms
100 ms
1000 ms
0 (off) to 900
changes
High
Low
Counter
Discrete
Signed integer
Unsigned integer
Long Signed
integer
Floating (Short 32-
bit IEEE format)
Double (Floating
64-bit IEEE format)
D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
Default
0