Table of Contents
Advertisement
D20E Ethernet I/O Module
Chapter 3: Configuring the D20E
Firmware
Set up procedure
D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
Configuring the D20E Firmware
This chapter describes the set up required to start operation of a D20E module. The D20E
module is then ready to be configured and monitored, and ready for the download of
projects files.
This chapter provides the following information:
•
Set up procedure
on page 37
•
Working with projects
•
Configuring D20E modules
•
Configuring points
on page 55
•
Digital input points
on page 55
–
Counter points
on page 60
•
Analog input points
on page 63
•
Control output points
•
Check operation of the D20E
•
Make D20E device setting changes
To set up for the configuring, monitoring and downloading of projects to the D20E module,
perform the following tasks:
1.
Connect the D20E module (port 1) to a Windows PC with an Ethernet cable as shown
in Figure 6.
A standard Ethernet cable can be used if connecting to a network with an Ethernet
switch.
on page 43
on page 49
on page 69
on page 73
on page 74
GE INFORMATION
37
Advertisement
Table of Contents
