Siemens SIPROCESS GA700 Compact Operating Instructions page 57

1. Prepare the Ethernet cable:
Figure 5-9
– Isolate the Ethernet cable
– Insert the Ethernet cable through the cable gland. Make sure that the exposed shielding
– Screw the cable gland closed.
2. Fasten the prepared gland at the device:
Figure 5-10
– Fasten the Ethernet cable in the cable gland
Connecting the Ethernet cable
1. Isolate the free cable end.
2. Assemble the stripped cores in a FastConnect plug.
3. Insert the Ethernet plug into the service interface of the processing module. You must feel for
the position of the interface.
Devices in explosion-proof design
Compact Operating Instructions, 01/2022, A5E35134047-11
①
Cable gland
②④
Contact shielding
③
Ethernet cable
⑤
Shielding braid
Ethernet cable shielding
a length of approx. 1 cm.
braid rests on the shield contact
⑥
Plate with cable glands
⑦
Position cable gland Ethernet cable (underside of the device)
Ethernet cable: Position of the cable gland
③
at the desired location so that the braid
② ④
or .
⑦
at the plate
Connecting
5.2 Electrical connections
⑤
is exposed over
⑥
.
57