Installing The Rack-Mounted Device - Siemens SIPROCESS GA700 Compact Operating Instructions

Installing
4.4 Rack-mounted device
Note
Installation in control cabinets
• Make sure there is adequate ventilation between the devices when installing in control
cabinets.
• Make sure that the permitted ambient temperature listed in the technical specifications is not
exceeded.
4.4.2

Installing the rack-mounted device

Dimension drawing
The following figure shows the dimensions of the rack-mounted device and the distance of the
fastening holes at the mounting brackets. The dimensions are specified in millimeters.
Figure 4-1
Procedure
1. Place the rack unit in the control cabinet or the enclosure.
2. Fasten the rack-mounted device in the control cabinet or enclosure with four screws at its
mounting brackets.
The dimensions for the drill holes are specified in the dimension drawing.
30
Dimension drawing
Devices in explosion-proof design
Compact Operating Instructions, 01/2022, A5E35134047-11