Yamaha RM1x Owner's Manual page 40

6. Effect block
How the effects work
• Variation = Insertion
When Variation connection is set to Insertion, the three
effects will be connected as shown in the diagram below.
Variation can be used only by one part
variation part
VAR
part 1
variation on/off
VAR
part 2
variation on/off
VAR
part 3
variation on/off
VAR
part 16
variation on/off
(pages 69, 120)
Of the 16 parts of the tone generator block, the signals of the
part specified by the Voice submode Variation on/off (pages
64, 120) will be input to the variation effect, and the variation
effect will be applied here.
The signals of all tone generator parts including the above-
mentioned part will be sent to the reverb effect and the chorus
effect according to the Voice submode settings Reverb Send
Level (pages 64, 120) and Chorus Send Level (pages 64, 120).
Here you can adjust the depth of the effect for each part.
40
RM1x SEQUENCE REMIXER
dry
volume expression
rev send
PAN
cho send
dry
volume expression
rev send
PAN
cho send
dry
volume expression
rev send
PAN
cho send
dry
volume expression
rev send
PAN
cho send
thick line indicates a stereo signal
reverb
pan
REVERB
PAN
send chorus to reverb
CHORUS
PAN
chorus
pan
DRY LINE
(pages 64, 120)
The stereo location of the effect output is determined by the
Effect submode settings Reverb Pan (pages 72, 121) and Cho-
rus Pan (pages 71, 121).
A bus line called Send Chorus To Reverb (pages 71, 121) con-
nects the chorus effect to the reverb effect. By using this bus
line you can connect the chorus effect and reverb effect in
series.
reverb
return
OUTPUT
chorus
return