NEC UNIVERGE SV8300 Pc Programming Manual page 78

No. Item
(2) System data
setup area (for
trunk blades)
(3) Trunk Blade No. field
(4) [Apply] button
(5) [Cancel] button
(6) [Fill In] button
(7) [Clear] button
Port No. Displays the number of port that houses the trunk.
CKT No. field Displays the line number on the blade.
Trunk Num- Enter a trunk number associated with the port numbers with
ber field three digits.
• 4 digits ["D" + 000 to 511, blank field] (default: blank
field)
Trunk Route Select a trunk route number according to the numbering
field plan setting.
• 00 to 63 (default: 01)
Select the trunk blade number.
• 000-127, NONE (No data) (default: NONE)
Click to write the detailed data settings to the SV8300.
Click to return to the [Blade Configuration] screen without
writing the detailed data settings to the SV8300.
Click to apply the settings entered on the first line to other
lines as well.
Station number and Trunk number
Numbers are assigned in sequence starting from the one on
the first line.
* Numbers containing * or # cannot be set.
Automatic entry stops before the first digit of a station
number change (example: 3999).
• Trunk Route field
The same value as that appearing on line 1 is set.
• Route Kind field
The same value as that appearing on line 1 is set.
• Port No. and CKT No. fields
Out of the scope of continuous entry.
Click to initialize the settings to their defaults.
Description
4-32
Chapter 4 Standard Mode
[Implement] Category
NWA-033628-001 Rev.1.0