NEC UNIVERGE SV8300 Pc Programming Manual page 219

Error Message
The Trunk Number xx has
already been registered.
The Trunk Number xx is not reg-
istered.
The Station Number xx has
already been registered.
The Station Number xx is not
registered.
First, read the data.
Cannot start up because that the
file could not be found or was
broken.
Reinstall the SV8300 PCPro.
Cannot start up because the
desired file is used in the other
application.
The file could not be found.
Failed to update the file.
Cause
– The specified trunk number is
already registered. Take either of
the following actions as appro-
priate:
1. Modify the trunk information.
2. Delete the trunk number once
– Register a trunk number first.
– The specified extension number
is already registered. Take either
of the following actions as appro-
priate:
1. Modify the station number
2. Delete the station number
– Register an station number first.
– Read data before writing it.
– Reinstall SV8300 PCPro.
– Retry.
– Specify a valid folder or browse
a valid file.
– Check to see if the file is not
read-only or if it is not used by
another application.
C-7
Appendix C Troubleshooting
Remedial action
and then register it again.
information.
once and then register it again.
Continued on next page
NWA-033628-001 Rev.1.0