NEC UNIVERGE SV8300 Pc Programming Manual page 221

Program Upgrade (On-line)
Error Message
There is no operation unit.
Input information of FTP Server. An attempt was made to set
Changeover Date/Time should
be established later than Upgrade
Date/Time.
Failed to copy the system data.
Click the 'Apply' button after a
while.
Firstly input information of an
unit01.
The following units have contra-
diction in the system data of the
'FTP Server Information'.
Unit No.: XX, XX, ...
Click the 'Apply' button when
you use the FTP Server of
SV8300 PCPro.
or confirm the contents of 'FTP
Server Information' when you
use the FTP Server except for the
SV8300 PCPro's.
Cause
No operating unit informa-
tion was available when it
was read from the scheduling
window.
the update date and time
when no FTP server infor-
mation had been entered.
A switching date and time
earlier than the update date
and time were appointed.
System data could not be
copied from unit01 to
another unit (flash memory
busy).
No information about unit01
was available at batch setup.
Program upgrade is not exe-
cuted correctly because there
is a contradiction on the sys-
tem data of the 'FTP Server
Information'.
C-9
Appendix C Troubleshooting
Remedial action
Check the system data.
Enter FTP server information.
The program is updated on
switching after the update pro-
cess. Appoint a switching date
and time later than the update
date and time.
Allow for a while before clicking
the [Apply] button once again.
Batch setup executes based on
the information about unit01.
Enter main unit information.
Assign the system data of the
'FTP Server Information cor-
rectly by the following actions.
- When using the SV8300 PCPro
as FTP server, click the [Apply]
button.
- When using the FTP server
except for SV8300 PCPro,
enter the correct information on
the detailed setup screen of FTP
server Information.
NWA-033628-001 Rev.1.0