Siemens Sinumerik 840D Operating Turning page 635

Simple programming example
Description:
A simple ShopTurn-program using the technology "Straight Circle" is to be
programmed.
Aim:
A new sequential program is to be created and opened in the editor.
The program header, several "Straight"-cycles and the program end are to
be programmed.
Afterwards the program is to be simulated.
For this, the data shown below are to be used:
Tool data: Finishing tool 35° (FINISHING_TOOL_35)
Technology data: S 1500 rpm
2.1 Creating a new ShopTurn program
A new ShopTurn program can be created in all operating modes, as fol-
lows:
1. Press the "Program Manager"-key on the keyboard.
The program manager opens directly.
- OR -
1. Press the "MENU SELECT"-key on the operator
panel.
Press the yellow HSK 4 "Program Manager".
The program manager opens.
2. Select a drive, where you want to create the pro-
gram by pressing the corresponding horizontal soft-
key ("NC", "Local drive", "USB").
3. Press the VSK 2 "New".
The vertical softkey bar for creating new programs
opens.
4. Press the VSK 3 "ShopTurn" to open the input mask
for creating a new ShopTurn sequential program.
Enter a name for the program in the "Name" field
and accept with pressing the VSK 8 "OK".
The program is loaded to the editor and the parame-
ter window for the program header is opened by de-
fault.
840D/828D SINUMERIK Operate
Section 2
Notes