Siemens SINUMERIK 840DE sl Commissioning Manual page 657

SD54640 $SNS_MEA_TPW_TRIG_MINUS_DIR_AX1[k]
SD54641 $SNS_MEA_TPW_TRIG_PLUS_DIR_AX1[k]
SD54642 $SNS_MEA_TPW_TRIG_MINUS_DIR_AX2[k]
SD54643 $SNS_MEA_TPW_TRIG_PLUS_DIR_AX2[k]
SD54644 $SNS_MEA_TPW_TRIG_MINUS_DIR_AX3[k]
SD54645 $SNS_MEA_TPW_TRIG_PLUS_DIR_AX3[k]
SD54646 $SNS_MEA_TPW_EDGE_DISK_SIZE[k]
SD54647 $SNS_MEA_TPW_AX_DIR_AUTO_CAL[k]
SD54648 $SNS_MEA_TPW_TYPE[k]
= 0
= 101
= 201
= 301
= 2
= 3
SD54649 $SNS_MEA_TPW_CAL_MEASURE_DEPTH[k]
SD54650 $SNS_MEA_TPW_STATUS_GEN[k]
SD54651 $SNS_MEA_TPW_FEED[k]
The following general cycle setting data SD54647 $SNS_MEA_TPW_AX_DIR_AUTO_CAL is
used to define in which axes and directions it is possible to calibrate a tool probe.
Decimal place
ONES
TENS
HUNDREDS
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
Compatibility (measuring cycles: cube, turning surface shows probe, milling surface shows
disk)
Disk in XY, working plane G17.
Disk in ZX, working plane G18.
Disk in YZ, working plane G19.
Probe
Cube
1st axis
= 0
= 1
= 2
= 3
2nd axis
= 0
= 1
= 2
= 3
3rd axis
= 0
= 1
21.10 Measuring cycles and measurement functions
axis not possible
only minus direction
only plus direction
both directions
axis not possible
only minus direction
only plus direction
both directions
axis not possible
only minus direction
Technologies and cycles
Trigger point of the 1st measuring axis
in the negative direction.
Trigger point of the 1st measuring axis
in the positive direction.
Trigger point of the 2nd measuring axis
in the negative direction.
Trigger point of the 2nd measuring axis
in the positive direction.
Trigger point of the 3rd measuring axis
in the negative direction.
Trigger point of the 3rd measuring axis
in the positive direction.
Tool probe, edge length / disk diameter.
Automatic calibration of tool probe, en‐
able axes/directions
Probe version
Distance between the upper edge of
the tool probe and lower edge of the
tool (calibration depth, measuring
depth for milling radius).
Calibration status
Measuring feedrate when calibrating
643