Siemens SINUMERIK 840DE sl Commissioning Manual page 648

Technologies and cycles
21.10 Measuring cycles and measurement functions
= 4
= 3
21.10.3.4 Measuring without electronic probe in JOG
Measure workpiece
For manual measuring functions in the JOG operating mode, for which a rotating spindle is
required, the following applies:
● The channel state must be reset at the instant in time that the measured value is transferred.
● The spindle can be moved or positioned either using the T,S,M menu or using the bits in
DB3x.DBB30.
● The following preconditions apply when using the DB3x.DBB30 technology functions with
fixed speed:
Setting the machine data
MD10709 $MN_PROG_SD_POWERON_INIT_TAB [0] = 0
MD35035 $MA_SPIND_FUNCTION_MASK
SD43200 $SA_SPIND_S
Note
The entry in SD43200 $SA_SPIND_S is kept at power on.
With these settings, the spindle velocity for manual operation, which is set in SD41200
$SN_JOG_SPIND_SET_VELO, is no longer effective.
21.10.4 Measuring in the AUTOMATIC mode
Requirement
You have already made the settings from Chapter "Measuring cycles and measurement
functions, general (Page 617)".
634
Read access rights: Access level 4 (keyswitch 3), default value
Write access: Access level 3 (user)
Software option
In order to use the "Measuring in AUTOMATIC" function, you require the software
option: "Measuring cycles"
Setting data to be initialized
Bit 4 = 0 Spindle functions
Bit 5 = 1
Speed setting value
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK Operate (IM9)