Siemens Sinumerik 802D sl Programming Manual page 34

Commands Calling Axis Movements
2.1 Interpolation commands
Example
G00 X44.0 C0 ;
G07.1 C45.0 ;
G01 G42 Z47.5 F100 ;
C60.0 ;
Z32.5 C120.0 ;
C240.0 ;
G03 Z40.0 C249.549 R7.5 ;
G02 Z47.5 C259.099 R7.5 ;
G01 C360.0 ;
Z44.0 ;
G07.1 C0 ;
M30 ;
Fig. 2-12
In the cylindrical interpolation mode, program restart is not possible. If program
restart is attempted from a block in the cylindrical interpolation mode, an alarm oc-
curs. However, program restart is allowed for blocks in which the cylindrical inter-
polation mode blocks are included.
2-34
Cutting tool
R
Coordinate system for cylindrical interpolation
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning -- 04.07 Edition
Z
C
Positioning at the start point of cutting
Cylindrical interpolation mode ON
Machining program
Cylindrical interpolation mode OFF
© SIEMENS AG 2007 All rights reserved
04.07