Channel-Specific Machine Data - Siemens Sinumerik 802D sl Programming Manual

Machine and Setting Data
D.2 Channel-specific machine data
D.2

Channel-specific machine data

20050
MD number
Default setting: 70
Changes effective after Power ON
Data type: BYTE
Meaning:
20060
MD number
Default setting: X, Y, Z
Changes effective after Power ON
Data type: STRING
Meaning:
20070
MD number
Default setting: 1, 2, 3, 4
Changes effective after Power ON
Data type: BYTE
Meaning:
20080
MD number
Default setting:
X, Y, Z, A, B, C, U, V, X11, Y11, ...
Changes effective after Power ON
Data type: STRING
Meaning:
D-212
AXCONF_GEOAX_ASSIGN_TAB
Assignment between geometry axis and channel axis
Minimum input limit: 0
Protection level: 2/2
This MD assigns a geometry axis to a channel axis.
The assignment must be made for all 3 geometry axes (X,Y,Z). If a geometry axis is not
assigned, the value 0 should be entered. The geometry axis is therefore not available and
cannot be programmed, e.g. if the second geometry axis is not required for the "turning"
technology Y - -> entry: value 0 (see default setting for turning).
AXCONF_GEOAX_NAME_TAB
Geometry axis name in channel
Minimum input limit: - -
Protection level: 2/7
This MD is used to enter the names of the geometry axes for the channel separately.
Geometry axes can be programmed in the part program using the names specified here.
AXCONF_MACHAX_USED
Machine axis number valid in channel
Minimum input limit: 0
Protection level: 2/7
This MD assigns a machine axis to a channel axis.
SINUMERIK 802D has 5 channel axes. Channel axis identifiers for the axes activated in
the channel must be specified in MD 20080: AXCONF_CHANAX_NAME_TAB. The axes
can be programmed.
A machine axis that has not been assigned to a channel axis is not active i.e. no axis
control, no display on the screen.
AXCONF_CHANAX_NAME_TAB
Channel axis name
Minimum input limit: - -
Protection level: 2/7
In this MD you can set the name of the channel axis.
The channel axis is displayed with this identifier in the WCS. This identifier is also written in
the program.
Generally, the first two or three channel axes are used as geometry axes (see also MD
20050: AXCONF_GEOAX_ASSIGN_TAB). The remaining channel axes are defined as
special axes. SINUMERIK 802D has 5 channel axes.
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
Maximum input limit: 20
Unit: - -
Applies with effect from SW version: 5.2
Maximum input limit: - -
Unit: - -
Applies with effect from SW version:
Maximum input limit: 31
Unit: - -
Applies with effect from SW version:
Maximum input limit: - -
Unit: - -
Applies with effect from SW version:
© SIEMENS AG 2007 All rights reserved
04.07